Extron electronic DVS 304 AD X1 CS WX1 CS IpsX1, X1$ CG, IpgX1$, X6$X1$ EB, BmdX6$ , X1$, X3# CA

3-20 DVS 304 • Serial Communication

Command/response table for IP control port commands (continued)

Command	ASCII (Telnet)	URL Encoded (Web)	Response	Additional description
	(host to processor)	(host to processor)	(processor to host)

IP setup commands, continued

Set subnet mask24	E X1(CS}	WX1(CS	Ips•X1( ]	X1( is the subnet mask (xxx.xxx.xxx.xxx).
				Syntax is the same as for the IP addresses
				Leading zeros are optional in setting values.
Read subnet mask	ECS} E	WCS	X1( ]	Leading zeros are suppressed.
Set gateway IP address24	E X1$CG}	W X1$CG	Ipg•X1$ ]	X1$ is IP address. Leading zeros are optional
Read gateway IP address	ECG}	WCG	X1$ ]
Set broadcast mode	E X6$X1$EB}	W X6$%2C X1$EB	BmdX6$, X1$ ]
Set administrator password 24	E X3#CA}	WX3#CA	Ipa•X3# ]	Set the administrator access password
				(X3# is 4-12 alphanumeric characters)
				The password is case sensitive. Special
				characters (spaces or symbols) are
				not allowed.
Clear administrator	E•CA}	W%20CA	Ipa• ]	Clear/remove all passwords
password 24				(administrator and user)

NA user password cannot be assigned if an administrator password does not exist. Entering a password when the DVS 304 has not been configured yields an E14 response from the processor. If the administrator password is cleared (removed), the user password is also removed.

Read administrator password	ECA}	WCA	X3# ]
Set user password14 24	E X3#CU}	WX3#CU	Ipu•X3# ]	Set the user access password
				(X3# is 4-12 alphanumeric characters)
				The password is case sensitive. Special
				characters (spaces or symbols) are
				not allowed.

NA user password cannot be assigned if an administrator password does not exist.

Clear user password24	E•CU}	W%20CU	Ipu•]	This clears the user password only
Read user password24	ECU}	WCU	X3#]

NX1$ = IP address (xxx.xxx.xxx.xxx); leading zeros in each of 4 fields are optional in setting values, and are suppressed in returned values.

X1( = Subnet mask (xxx.xxx.xxx.xxx). Leading zeros are optional in setting values in each of four fields, and are suppressed in returned values. X3# = Password (12 characters = maximum length; no special characters are allowed).

X6$ = Broadcast repetition rate in seconds (0 – 255 max; default = 0 = clear). The response is returned with leading zeros. 1 – 11 = entry without password goes to the level pecified (if an admin password exists). The response as returned

as 2-digits with a leading zero.

Serial Communication, cont’d