Philips AZ 1030 manual Power Supply, Batteries optional, AC power supply

POWER SUPPLY

Batteries (optional)

Open the battery compartment of the set and insert 6 batteries, type R20, UM-1, or D-cells (preferably alkaline).

Remove batteries if they are dead or if the set is not going to be used for a long time.

Batteries contain chemical substances, so they should be disposed of properly.

English

AC power supply

1Check whether the voltage as shown on the type plate corresponds to your local voltage. If it does not, consult your dealer or service organization. The type plate is located on the bottom of the set.

2If the set is equipped with a VOLTAGE selector A, set this selector to the local voltage.

3Connect the AC power cord to the AC MAINS socket and to the wall socket. This switches on the AC power supply. The AC power cord is inside the battery compartment.

The battery supply will be switched off when the set is connected to the AC power. To change to battery supply, disconnect the AC power cord from the unit’s AC MAINS socket.

To disconnect the set from the AC power completely, remove the AC power cord from the wall socket.

A

The set complies with the FCC-Rules, Part 15 and with 21 CFR 1040.10. Operation is subject to the following two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired operation.

7