INSTALLATION | ||
|
|
|
I / O RECEPTACLE SPECIFICATIONS
TABLE A.2
WIRE FEEDER RECEPTACLE
PIN LEAD# | FUNCTION |
A53 Communication Bus L
B54 Communication Bus H
C67A Electrode Voltage Sense
D | 52 | 0vdc - | } 40VDC |
E | 51 | +40vdc + |
TABLE A.3
VOLTAGE SENSE RECEPTACLE
PIN LEAD# | FUNCTION |
321A Work Voltage Sense
TABLE A.4
RS232 RECEPTACLE
PIN LEAD# | FUNCTION |
2253 RS232 Receive
3254 RS232 Transmit
4 | # | Pin5 |
5 | # | Pin4 |
6 | # # | Pin20 |
20 | # # | Pin6 |
7251 RS232 Common
DIP SWITCH SETTINGS AND LOCATIONS
DIP switches on the P.C. Boards allow for custom configuration of the Power Wave. To access the DIP switches:
WARNING
ELECTRIC SHOCK can kill.
switch 7 |
| auto mapping |
off |
| auto mapping |
on |
| auto mapping disabled |
|
|
|
switch 8* | work sense lead | |
off | work sense lead not connected | |
on | work sense lead connected | |
|
|
|
*Factory setting for Switch 8 is OFF.
FIGURE A.7
CONTROL BOARD (DIP Switch Location)
1.Turn off power to the power source at the dis- connect switch.
•Insulate yourself from the work and ground.
•Always wear dry insulating gloves.
2.Remove the wrap around cover from the power source.
3.The control board is on the center assembly facing the case front. Locate the
4.Using a pencil or other small object, slide the switch to the OFF position if the work sense lead is NOT connected. Conversely, slide the switch to the ON position if the work sense lead is present.
5.Replace the wrap around and screws. The PC board will “read” the switch at power up, and configure the work voltage sense lead appropriately.
FIGURE A.8
CONTROL BOARD DIP SWITCH:
switch 1 = reserved for future use
switch 2 = reserved for future use
switch 3 = equipment group 1 selcted (default=off) switch 4 = equipment group 2 selcted (default=off)
switch 5 = reserved for future use switch 6 = reserved for future use switch 7 = auto mapping switch 8 = work sense lead
(See Figure A.8 for Dual Head Boom Feeder)
POWER WAVE 355M