INSTALLATION | ||
|
|
|
3.Proper placement of the equipment on the trailer to insure stability side to side and front to back when being moved and when standing by itself while being operated or serviced.
4.Typical conditions of use, i.e., travel speed; rough- ness of surface on which the trailer will be operated; environmental conditions.
5.Conformance with federal, state and local laws(1)
(1)Consult applicable federal, state and local laws regarding specific requirements for use on public highways.
VEHICLE MOUNTING
Improperly mounted concentrated loads may cause unstable vehicle handling and tires or other components to fail.
•Only transport this Equipment on serviceable vehicles which are rated and designed for such loads.
•Distribute, balance and secure loads so vehicle is stable under conditions of use.
•Do not exceed maximum rated loads for compo- nents such as suspension, axles and tires.
•Use appropriate nuts bolts and lockwashers to attach the equipment base to the metal bed or frame of vehicle.
•Follow vehicle manufacturer’s instructions.
FUEL
Fill the fuel tank with clean, fresh,
WARNING
•Damage to the fuel tank may cause fire or explosion. Do not drill holes in the WELDMARK 225 base or weld to WELDMARK 225 base.
LUBRICATION SYSTEM CAPACITY
(INCLUDING FILTER) Kohler CH23S - 2.0 Quarts (1.9 Liters)
OIL
The Weldmark 225 is shipped with the engine crankcase filled with SAE
PRE-OPERATION SERVICE
CAUTION
READ the engine operating and maintenance instructions supplied with this machine.
WARNING
BATTERY CONNECTIONS
CAUTION
Use caution as the electrolyte is a strong acid that can burn skin and damage eyes.
This welder is shipped with the negative battery cable disconnected. Make sure that the Engine Switch is in the “STOP” position and attach the disconnected
GASOLINE
can cause fire or explosion.
•Stop engine while fueling.
•Do not smoke when fueling.
•Keep sparks and flame away from tank.
•Do not leave unattended while fueling.
•Wipe up spilled fuel and allow fumes to clear before starting engine.
•Do not overfill tank, fuel expan- sion may cause overflow.
cable securely to the negative battery terminal before attempting to operate the machine. If the battery is discharged and does not have enough power to start the engine, see the battery charging instructions in the Battery section.
NOTE: This machine is furnished with a wet charged battery; if unused for several months, the battery may require a booster charge. Be careful to charge the bat- tery with the correct polarity.