Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
| ||||
|
| TROUBLESHOOTING & REPAIR | ||
|
| OUTPUT TRANSISTOR REMOVAL AND REPLACEMENT (continued) | ||
| PROCEDURE |
|
| |
1. | Remove input power to the | 3. | Perform the Input Filter Capacitor Discharge | |
|
|
|
| Procedure detailed earlier in this section. |
2. | Using a phillips head screwdriver, remove the case | 4. | Locate the output transistor. See Figure F.36. | |
|
| wraparound cover. | ||
FIGURE F.36 OUTPUT TRANSISTOR LOCATION
Output
Transistor
Return to Section TOC
to Section TOC
Return to Master TOC
Return to Master TOC
5.Disconnect plug CN1 from the output transistor.
See Figure F.37.
6.Using a phillips head screwdriver, disconnect leads 1, 2 & 3. See Figure F.37.
7.Using a 5mm allen wrench, remove the output tran- sistor mounting bolts.
8.Remove and replace the output transistor.
NOTE: Be careful not to bend the copper bus bars.
9.Apply a thin layer of heatsink compound to all con- tact surfaces.
10.Replace the output transistor mounting bolts pre- viously removed.
11.Reconnect leads 1, 2 & 3 previously removed.
12.Reconnect lead CN1.
13.Replace the case wraparound cover.
Return