Lincoln Electric 205-TAC/DCTIG manual Safety Precautions, Routine Maintenance

Page 29

D-1

MAINTENANCE

D-1

 

 

 

SAFETY PRECAUTIONS

WARNING

ELECTRIC SHOCK can kill.

• Have an electrician install and ser- vice this equipment.

•Turn the input power off at the fuse box, disconnect or unplug supply lines and allow machine to sit for five minutes minimum to allow the power capacitors to dis- charge before working inside this equipment.

•Do not touch electrically hot parts.

----------------------------------------------------------------------

INPUT FILTER CAPACITOR

DISCHARGE PROCEDURE

WARNING

The machine has internal capacitors which are charged to a high voltage during power-on condi- tions. This voltage is dangerous and must be dis- charged before the machine can be serviced. Discharging is done automatically by the machine each time the power is switched off. However, you must allow the machine to sit for at least 5 min- utes to allow time for the process to take place.

------------------------------------------------------------------------

ROUTINE MAINTENANCE

Prevent metal powder from accumulating near the aeration fins and over them.

Carry out the following periodic controls on the power source:

•Clean the power source inside by means of low- pressure compressed air.

•Check the electric connections and all the connec- tion cables.

•Always use gloves in compliance with the safety standards.

V205-T DC & V205-T AC/DC TIG

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Invertec V205-T DC & V205-T AC/DC TIG April California Proposition 65 Warnings SafetyElectric Shock can kill Iii Welding and Cutting Sparks can Cause fire or explosionSûreté Pour Soudage a LʼArc Précautions DE SûretéV205-T DC & V205-T AC/DC TIG Safety Thank You Table of Contents Storage Temperature Range InstallationOperating Temperature Range Stacking Select Suitable LocationTilting Environmental AreaInput Connections Reconnect ProcedureTable A.1 Nominal Range230V Input Attachment Plug Installation115V Input Engine Driven GeneratorWork Cable Connection Output and GAS Connection for TIG Welding Figure A.1Output Connection for Stick Welding Figure A.2 Shielding GAS Connection Remote Control ConnectionOperation Safety InstructionsGeneral Description Welding CapabilityFigure B.1 Rear Control Panel Figure B.1Figure B.2 Controls and SettingsStep Diagram TIG DC Indicator Parameter Default SET UP MenuWelding Polarity Output LimitationsAlternating Current AC/DC model only Pulsed TIGCopper TIG Welding Steel TIG WeldingTips for AC TIG Welding Filler MaterialProtective GAS Tips for Improved TIG StartingAC TIG AC TIG Welding Quick Start UPDC TIG Welding Quick Start UP Optional Accessories AccessoriesCompatible Equipment Cable PlugsSafety Precautions MaintenanceInput Filter Capacitor Discharge Procedure Routine MaintenanceHOW to USE Troubleshooting Guide TroubleshootingTroubleshooting Your local Lincoln Authorized Problems TIG WeldingField Service Facility Display FailuresV205-T DC Wiring Diagram for Wiring DiagramsV205-T AC/DC Wiring Diagram for V205-T DC & V205-T AC/DC TIG V205-T DC & V205-T AC/DC TIG Precaucion Warnung
Top Page Image Contents