Bevel cutting

Loosen the lock lever clockwise, then tilt the blade by swinging the knob until it reaches the desired angle ( 0 to 45 degrees). The bevel is indicated on the scale by the pointer (B). After obtaining the desired angle, tighten the lock lever counterclock- wise to secure the adjustment.

CAUTION :

After adjusting the bevel, be sure to tighten the lock lever securely.

Adjusting stopper plate

Secure the lock lever a t the position where the lock lever contacts the stopper plate. Make sure the blade is a t 90 degrees or 45 degrees to the table surface. If the bevel is not a t 90 degrees or 45 degrees, proceed as follows:

:I, Use the hex wrench to loosen the bolt securing the stopper plate.

ZLoosen the lock lever and adjust the blade to 90 degrees or 45 degrees, then secure the lock lever.

3 Slide the stopper plate until it contacts the lock lever, then tighten the bolt securely.

@ Make sure the pointer (B) points to the 0" or 45" graduation on the bevel scale when the blade is a t 90 degrees or 45 degrees. I f it does not point to the 0" or 45" gradua-

o!,ti

loosen the screws holding the pointer (B) and align the pointer (B)with the 0" or

45graduation. Then tighten screws. (Note: The screws holding the pointer (B) are located inside the base.)