Install the blade between the two flanges. Then install the outer flange and hex nut onto the arbor, making sure the teeth of the blade are pointing down a t the front of the table.
To secure the blade in place, hold the outer flange with the offset wrench, then tighten the hex nut counterclockwise with the wrench. When tightening the hex nut, the offset wrench handle should be supported by the table as shown in the figure. BE SURE TO TIGHTEN THE HEX NUT SECURELY.
CAUTION :
Be sure to hold the hex nut carefully with the wrench. If your grip should slip, the wrench may come off the hex nut, and your hand could strike the sharp blade edges.
9