Makita 2711 instruction manual Blade and spreader are in a straight line

Installing blade guard

CAUTION :

Before installing the blade guard, adjust the depth of cut to i t s maximum elevation. (Note: The depth of cut is adjusted to i t s maximum elevation when the table saw is shipped from the factory.)

Temporarily tighten the bolts with the
offset wrench. Check to be sure that the		These two clearances
blade and spreader are in a straight line.
	r--l	should be equal.
If they are not properly aligned, shift the			h
adjusting washers from one side to another	washer
until the spreader is aligned directly behind
the blade.		Spreader	Blade
	/KBolt'
	Pressure plate

CAUTION :

If the blade and spreader are not aligned properly, a dangerous pinching condition may result during operation. Make sure they are properly aligned.

There must be a clearance of about 4 - 1I	Soreader- ,----	1I
5 mm (5/32"-13/64") between the spreader

and the blade teeth. Adjust the spreader accordingly and tighten the bolts securely. Attach the table insert on the table, then check to see that the blade guard works smooth.

CAUTION :

Be sure to tighten the screws securely after installing the table insert.

12