Push block
Use a 19 mm (3/4") piece of plywood.
120. mm |
| (5") |
Faceledge |
| ( 5 " ) |
parallel | 6 mm |
|
| 5o mm | |
| (1/4"l | |
|
| (2") |
Handle should be in center of plywood piece. Fasten with glue and wood screws as shown. Small piece 9.5 mm x 8 mm x 50 mm (3/8"x 5/16" x 2") of wood must always be glued to plywood to keep the blade from dulling if the operator cuts into push block by mis- take. (Never use nails in push block.)
Auxiliary fence
Make auxiliary fence from 9.5 mm (3/8") and 19 mm (3/4")plywood pieces.
4 0 mm
| (1 |
9.5 mm | 19 mm (314'') |
|
Faceledge |
|
parallel | |
( 1 8 " ) |
Fasten with glue and wood screws.
Wood facing (Rip fence)
A wood facing should be used for opera- tions when the blade comes close to the rip fence. Wood facing for the rip fence should be same size as the rip fence.
Make sure the bottom of facing is flush with the table surface.
18