Crosscutting
CAUTION :
When making a crosscut, remove the rip fence from the table.
When cutting long or large workpieces, always provide adequate support to the sides of the table. The support should be a t the same height as the table.
(1; Loosen the wing bolt securing the sliding table.
0)Adjust the blade to 90 degrees to the table surface. Adjust the miter gauge to
0 degree. Switch the tool on and move the sliding table forward to cut the wooden gauge.
Align the cutting line on the workpiece with the end of the wooden gauge.
131 Adjust the depth of cut a bit higher than the thickness of the workpiece. Firmly hold the workpiece flush against the miter gauge and move the sliding table forward gently to cut the work- piece.
Miter cutting
Adjust the miter gauge to the desired angle ( 0 to 45 degrees) and tighten the miter gauge installation screws securely. Follow the same procedure as’mentioned in @ for crosscutting.
19