Refrigerant Cycle, Power Cord, Condenser

2.3.6 POWER CORD

1.Disconnect the unit from source of power.

2.Remove the front grille. (Refer to Section 2.1.1)

3.Remove the cabinet. (Refer to Section 2.1.2)

4.Remove a screw that secures control panel to base pan. (Refer to Section 2.1.3)

5.Pulls the control panel toward you.

6.Disconnect the 2 receptacles and remove the grounding screw.

7.Remove a screw securing the clip with cord to the control board.

8.Pull the power cord.

9.Re-install by referring to procedures above.

1.Remove the cabinet. (Refer to Section 2.1.2)

2.Discharge the refrigerant by using a refrigerant recovery system.

3.Remove the air guide. (Refer to Section 2.2.1)

4.Remove 2 screws which fasten the condenser.

5.After discharging the refrigerant completely, unbraze the interconnecting tube at the condenser connections.

6.Remove the condenser.

7.Re-install by referring to the procedures above.

Figure 18

Figure19

— 9—