Xantrex Technology 10 owner manual Residential Solar Installation

Page 32

Installation

Residential Solar Installation

Before installing the inverter in a residential solar application, you must consider factors such as:

“Location” (see page 2–16)

“Grounding” (see page 2–17)

“Neutral Bonding” (see page 2–17)

“AC Wiring” (see page 2–18)

“Residual Current Circuit Breaker” (see page 2–19)

“Remote Control Wiring” (see page 2–19)

“DC Wiring” (see page 2–20)

“Battery Cable Fusing” (see page 2–21).

Location

The following factors should be considered when planning to install the

Freedom 10.

1.The chassis ground bonding lug is located on the bottom of the unit. Be sure to make this connection before bolting the unit down.

For future use

May be used with optional TC 2+2 (Battery Temp. Sensor)

Remote Jack

Chassis Ground

Bonding Lug

Figure 2-9Ground, AC, and Remote Connection Locations

2.Always mount the unit in a dry area, out of direct contact with water or spray.

3.You may mount the unit horizontally (on a shelf) or vertically (on a wall). If mounted vertically, you must orient the unit so the switch and circuit breakers are facing up and the fan and battery cables are facing down.

2–16

975-0251-01-01

Image 32
Contents Freedom Inverter/Charger Page Freedom 10 Inverter/Charger Date and Revision Purpose Scope AudienceConventions Used Related InformationPage Important Safety Instructions Explosive gas precautions Precautions When Working With BatteriesPrecautions for Using Rechargeable Appliances Viii Contents Troubleshooting SpecificationsOperation GlossaryIntroduction Introduction 1Freedom 10 Inverter/ChargerCircuit Breaker Protection Things You Should KnowIntended Use Inverter ldle Circuit Power SharingElectronic Protection Installation Installation Precautions Appropriate ApplicationsKey Installation Points Recreational Vehicle Installation LocationGrounding Neutral BondingAC Wiring Wire Color DescriptionRemote Control Wiring Residual Current Circuit BreakerDC Wiring DC EndBattery Cable Fusing 4Fuse installationMarine Installation 5Ground, AC, and Remote Connection LocationsMarine Installation 6AC Compartment Cover Plate Screws Residual Current Circuit Breaker DC Wiring 8Fuse installation Residential Solar Installation 9Ground, AC, and Remote Connection LocationsResidential Solar Installation 10AC Compartment Cover Plate Screws Residential Solar Installation 11 DC End 12Fuse installation Page Operation Models Freedom 10 Power SwitchRemote Control Panel Power Switch DC Volts Bar Graph 4Freedom Remote Control Dip Switches DIP Switch Status Link 2000 Remote Control Panel Remote Power ConsumptionBattery Types BatteriesBattery Interconnection SeriesParallel 4Typical Power Consumption Freedom Battery Charger Battery ChargingConventional Battery Chargers Bulk Charge Equalizing Batteries Charging Over-Discharged Batteries Battery Charger Voltage Settings 5Battery Charger Voltage SettingsTroubleshooting Using the Remote Control DC Amps LED Bar Graph Troubleshooting GuideSpecifications Specifications 12 VDC 24 VDCGlossary Glossary of Terms AWGLED Page Warranty and Return Information WarrantyExclusions DisclaimerProduct Out of Warranty Service Return Material Authorization PolicyReturn Procedure Information About Your System Purchased From Purchase DatePage Xantrex Technology Inc
Related manuals
Manual 48 pages 54.2 Kb