Xantrex Technology 10 owner manual Power Switch

Remote Control Panel

24 V Models

This section contains information about the remote control panel for 24 V models. The remote control panel provides LED bar graphs that show system status, battery voltage, and current in both inverter and charge modes. These bar graphs can also display DIP switch positions and shutdown conditions.

Figure 3-3Remote Control Panel for 24 V Models

Power Switch

The switch on the remote is used to control the inverter and can be used to control the battery charger function also. When a remote control is used, the power switch on the unit itself should be left in the OFF position.

System Status LEDs

These four LEDs monitor the system as described in Table 3-1.

Table 3-1System Status LED summary

Status LED	Appearance	Purpose
BATTERY	On Steady	This is a warning condition.
		Inverter mode: Battery > 30.5 or < 21 volts
		Charger mode: Battery > 30.5 or < 20 volts.
BATTERY	Blinking	Indicates either a shutdown or equalizing.
		Battery > 31 volts will automatically reset at 30.5.
		Inverter mode: Battery < 20 volts, will
		automatically reset at charger float voltage or upon
		AC input.
		Charger mode: Battery < 16 volts for 1 minute,
		remove all DC loads and manually reset by cycling
		the power switch.
OVERLOAD	On Steady	Indicates an over-temperature condition, the unit is
		shut down.

975-0251-01-01 3–3