Xantrex Technology 10 owner manual Link 2000 Remote Control Panel, Remote Power Consumption

			Link 2000 Remote Control Panel
Table 3-2DIP switch function and position summary
Feature	Switch Number			Set Point
	Off			Enable: Charger on when
				AC connected.*
Idle Sensitivity	5	6
	On	On		Idle disabled
	Off	On		15 watts
	On	Off		6 watts
	Off	Off		4 watts*
Power Sharing	7	8
	On	On		2 amps
	Off	On		5 amps
	On	Off		10 amps
	Off	Off		15 amps*

*Default setting.

**Refer to voltages under “Battery Charger Voltage Settings”.

Remote Control Wiring

The remote control panel is supplied with 7.62 m or 15.24 m of RJ11 remote cable. The cable supplied may have 6 conductors; however, only 4 conductors are required. You may buy standard 4-conductor telephone cable and run up to

15.24 m if desired. Use only a single length of telephone wire—do not splice.

Remote Power Consumption

Table 3-3System current consumption versus idle mode

Idle Mode	With Remote	Without Remote
Normal Idle	181 mA	120 mA
Idle Circuit Disabled	496 mA	n/a
Unit Shut Off	16 mA	7 mA

Link 2000 Remote Control Panel

The Link 2000 and 2000R offer increased monitoring and control options. In addition to providing inverter/charger control, the Link 2000 enables precision monitoring of DC voltage, current, and amp hours for two battery banks.

The Link 2000R adds the ability to control an engine driven alternator. This precision regulator transforms an alternator into a 3 stage battery charging system like the charger in the Freedom 10.

If a Link 2000 or 2000R remote is being used to control the inverter/charger, refer to the Link manual for setup and control information.

975-0251-01-01 3–7