Studer Innotec XTH 5000-24, XTH 6000-48, XTH 8000-48 operating instructions Studer Innotec Xtender

STUDER Innotec			Xtender
No. of	Denomination / description	Units	Fact.	Mod.
config.			value	value
1298	Increment step of the adaptive low voltage method	mV/cell	20
1300	Number of overloads permitted before definite stoppage	--	3
1303	Number of battery overvoltages accepted before definite stoppage	--	3
1304	Number of battery undervoltages permitted before final stop	--	3
1307	Reset voltage for adaptive correction	V/cell	2.2
1309	Minimum ACin voltage to authorise charging	Vac	185
1403	Period for counting battery overvoltages	sec.	60
1404	Period for counting battery undervoltages	sec.	0
1432	Maximum ACin voltage to switch to inverter mode	Vac	270
1433	Adaptation range of the charge current according to the input	V	20
	voltage
1436	Allow to exceed AC input current without opening the transfer relay	y/n	yes
1470	ACin voltage hysteresis for closing the transfer relay	Vac	10
1485	Automatic earth-neutral connection in inverter mode	y/n	no
1488	Critical under voltage of the battery	V/cell	1.5
1505	Delta of higher frequency accepted	Hz	15
1506	Delta of lower frequency accepted	Hz	5
1516	Auxiliary contact 1 deactivated by floating mode	y/n	yes
1517	Auxiliary contact 2 deactivated by floating mode	y/n	no
1527	Decrease max input limit current with AC-In voltage	o/n	n
1528	Delay before closing transfer relay	Min.	0
1532	Kind of dynamic compensation	Auto/Man	Auto

To modify the configurations, please refer to the operating instructions for the RCC-02/03 remote control

Installation and operating Instructions Xtender V1.3 Page 35