English
Operating Procedures
WARNING: Do not operate this unit until you read and understand this instruction manual for safety, operation and maintenance instructions.
Start-up (Fig. 1)
1.Follow Pre-Start Checklist under Preparation for Use.
2.Move the On/Off switch to the ON position and allow tank pres- sure to build. Motor will stop when tank pressure reaches cut‑out pressure.
CAUTION: Risk of unsafe operation. Compressed air from the unit may contain water condensation. Do not spray unfiltered air at an item that could be damaged by moisture. Some air operated tools or devices may require filtered air. Read the instructions for
the air tool or device.
3.Adjust regulator (D) to desired setting. See Regulator under Features.
Shut-down (Fig. 1)
1.Move On/Off switch (A) is in the OFF position. NOTE: If finished using compressor, follow Steps
NOTE: When the unit has been turned off, it is normal to hear a short hiss of air being released.
2.Turn regulator knob (D) counterclockwise until fully closed. Ensure regulated pressure gauge reads 0 psi.
3.Remove hose and accessory.
NOTE: Always turn off and unplug unit when not in use.
Warning: Risk of unsafe operation. Firmly grasp air hose in hand when installing or disconnecting to prevent hose whip.
4.Drain the air tank, see Draining Air Tank under Maintenance. Ensure air tank pressure gauge reads 0 psi.
Warning: Risk of bursting. Drain air tank daily. Water will con- dense in air tank. If not drained, water will corrode and weaken the air tank causing a risk of air tank rupture.
5.Allow the compressor to cool down.
6.Wipe air compressor clean and store in a safe,
Maintenance
The following procedures must be followed when maintenance or service is performed on the air compressor.
1.Ensure On/Off switch is in the OFF position.
2.Remove air compressor plug from outlet.
3.Drain air tank.
4.Allow air compressor to cool down before starting service. NOTE: All compressed air systems contain maintenance parts (e.g., oil, filters, separators) that are periodically replaced. These used parts may contain substances that are regulated and must be disposed of in accordance with local, state, and federal laws and regulations. NOTE: Take note of the positions and locations of parts during disassembly to make reassembly easier.
NOTE: Any service operations not included in this section should be performed by a DeWALT factory service center or a DeWALT authorized service center.
Maintenance Chart
Procedure | Before Each | Daily or after | See tank |
| Use | each use | warning label |
Check safety valve | X |
|
|
Drain air tank |
| X |
|
|
|
|
|
Remove tank from |
|
| X1 |
service |
|
|
|
1- For more information, call
12