Grizzly G0664 owner manual WorkstopVise, To install the workstop, To use the vise

WorkstopVise

The Model G0664 has an adjustable workstop that is easy to install and use.

To install the workstop:

1.Thread the workstop rod into the base and tighten.

2. Slide the workstop onto the rod.
Hex Bolt	Jam Nut	Lock
		Knob
Workpiece
Workstop Rod
Workstop	Set Screw

Figure 29. Workstop assembly.

3.Measure the distance from the blade to the workstop, slide the workstop to the needed position, then tighten the set screw.

Note: Fine adjustments can be made by loosening the jam nut, adjusting the hex bolt as needed, then re-tightening the jam nut.

The Model G0664 vise is hydraulically assisted. Once the vise jaws are manually positioned close to the workpiece, the vise open/close buttons can be used to quickly and easily release and re- clamp the workpiece hydraulically during repeti- tive operations.

To use the vise:

1.Raise the bow ().

2.Press the vise open button ().

3.Insert the workpiece between the jaws.

4.Use the handwheel (Figure 30) to move the jaws to within 1⁄4" of the workpiece.

Handwheel

Figure 30. Vise options and controls.

5.Use the vise close button () to clamp the workpiece. Between cuts, use the open vise

button () to release and reposition/reload a new workpiece.

Note: As a safety precaution, the vise close

button () must be pressed before the saw motor will start.

-28- G0664 Heavy Duty Metal-Cutting Bandsaw