Grizzly G0664 Leveling Feet, Machine Leveling, To install the leveling feet, To level the machine

Leveling Feet

Each corner of the Model G0664 base has a foot with a threaded hole that can be used to level the machine.

To install the leveling feet:

1.Place the machine on blocks at least 4" above the ground so that each threaded hole can be accessed from underneath.

2.Insert one M16-2 x 50 hex bolt with an M16-2 hex nut into each of the feet, as shown in

Figure 11.

Hex Nut

Hex Bolt

Figure 11. Leveling feet.

3.Lift the machine, remove the blocks, then place the machine into its final location.

4.Proceed to Leveling Machine.

-18-

Machine Leveling

Whether you mount the machine to the shop floor, use machine mounts, or use the leveling feet, the Model G0664 must be leveled before use.

To level the machine:

1.Using a level placed on the vise table as a guide, level the machine by adjusting one side up or down as needed, using shims, machine mounts, or the leveling feet. Be sure to adjust each side in small, equal increments as one adjustment also affects the other side.

2.Once the machine is level in one direction, rotate the level 90˚ and check again for level.

3.Again adjust the machine as needed. Be sure to use small, equal increments on each side.

4.Re-check for level in both the left-to-right and front-to-rear directions. Re-adjust if neces- sary.

5.Once the machine is level, secure the mount- ing hardware as necessary, depending on the mounting method you have chosen.

G0664 Heavy Duty Metal-Cutting Bandsaw