Extension Wings
NOTICE
The Model SM has sheet metal wings; the Models Z, ZF, and ZFX uses slotted cast iron wings; and the Models PROZ & PROZX use solid cast iron wings. Installation is identical with all styles.
To install the extension wings:
1.Attach the extension wings to the table using M10 - 1.5 x 25 hex bolts and M10 flat wash- ers.
2.Thread the center bolt in first, then the front and back bolts. DO NOT completely tighten the bolts at this time.
3.Working front to back, align the front edge of the extension wing with the edge of the table, so they are flush, and tighten the front bolt.
4.Raise or lower the rear of the extension wing until the middle of the wing is flush with the table top and tighten the middle bolt as shown in Figure 23.
Figure 23. Checking table to wing alignment.
5.Raise or lower the rear of the wing until the wing and table are flush. Tighten the bolt.
6.Repeat Steps 2-5 for the other extension wing.
7.Check the alignment of the table against both wings. Your straightedge should run flat across both wings and the table top. If the straightedge contacts both the wings and the table evenly, you may skip to the next sec- tion. If it does not, continue to Step 8.
8.If either wing tilts down, remove it and apply layers of masking tape along the entire edge of the wing under the bolt holes.
9.If the wing tilts up, apply layers of masking tape along the entire edge of the wing above the bolt holes.
10.Tighten bolts and adjust again as described in Steps 2-5.
11.Trim off the excess masking tape with a razor blade.
|
|
|
|
|
|
|
|
|
|
|
|
G1022 Series Table Saws | |||