Table Insert
The table insert provides support for the material being cut. It must be installed flush with the cast iron table surface.
To install the table insert:
1.Disconnect the machine from the power source!
2.Using the front handwheel, move the blade to its lowest position.
3.Set the table insert into the recessed area on the table surface.
4.Ensure that all four table insert setscrews are firmly in contact with the table casting.
5.Using an allen wrench, raise or lower each of the four setscrews until the insert is flush with the table top as shown in Figure 42.
6.Using the side handwheel, position the blade 90¡ to the table surface.
Wear leather gloves when rotating the saw blade. Failure to follow this warning could result in serious per- sonal injury or death.
7.Wearing leather gloves, rotate the blade while raising and lowering it through its full range of motion. Make sure it never contacts any part of the table insert.
8.Repeat Step 6 with the blade in the 45¡ posi- tion.
Allen Wrench
Setscrew
Table Insert
Figure 42. Adjusting table insert components.
G1022 Series Table Saws |