Grizzly G1022ZFX instruction manual HandwheelsMotor, Attaching pulley guard bracket

To mount the handwheels:

1.Position a handwheel over the arbor raising shaft on the front of the saw. Be sure it fits completely over the shaft. The slots in the handwheel hole will engage with the roll pin on the shaft as shown in Figure 12.

2.Position the other handwheel similarly on the blade tilting shaft located at the side of the saw.

3.Screw the black plastic lock knobs onto the ends of the shafts to lock the handwheels in place.

Roll Pin

Body mounted switch on

G1022SM and Z only

Figure 12. Mounting the handwheels.

The following pictures show the motor and V-belt included with the Model G1022SM and Z. The motor and belt included with the Model G1022ZF, ZFX and PRO will look slightly different but will assemble in the same manner as shown.

To mount the motor:

1.Turn the motor upside down and attach the motor plate using M8-1.25 x 25 hex bolts, 8MM flat washers and M8-1.25 hex nuts as shown in Figure 13. Finger-tighten only.

Note: Motor comes

pre-wired.

Figure 13. Attaching the motor plate.

2.Insert the 1Ú4''-20 x 2'' hex bolt through the hole in the pulley guard bracket as shown in Figure 14.