Grizzly G1022ZFX Table Insert, Adjusting table insert height G1022 Series Contractor Saws

Table Insert

!Disconnect power to themachine when perform-

ing any maintenance, assembly or adjust- ments. Failure to do this may result in serious personal injury.

The table insert provides access to the blade and arbor when removed. When in place, the insert provides support for materials being cut.

1.Disconnect the power cord from the outlet.

2.Ensure that all four setscrews are firmly in contact with the table casting.

3.Using a 6mm hex wrench, raise or lower each of the four setscrews until the insert is flush with the table top as shown in Figure 31.

4.Now make sure the blade will not come into contact with table insert. Position the blade at 90¡, then raise and lower the blade through its full range of motion. Also rotate the blade while doing this, making sure that the blade never contacts any part of the table insert. Do the same with the blade in the 45¡ position. Wear leather gloves while rotating the blade to prevent being cut.

5.Be sure to review Section 5: Adjustments, “Blade Parallelism,” before operating the saw.

-26-

Allen¨ Wrench

Setscrew

Table Insert

Figure 31. Adjusting table insert height.

G1022 Series Contractor Saws