Positioning the
Control Panel
Tools Needed | Qty |
Hex Wrench 8mm | ............................................. 1 |
To mount the control panel:
1.Unwrap the protective covering from the con- trol panel and support arm.
2.Place the control panel support arm into the mounting bracket as shown in Figure 14.
| Cap Screw |
| Mounting |
Cap Screw | Bracket |
|
Figure 14. Control panel assembly.
3.Position the control panel for easy access, as shown in Figure 15, and tighten the cap screws shown in Figure 14.
Mounting the |
|
Return Rollers |
|
Tools Needed | Qty |
Wrench/Socket 17mm | 1 |
To mount the return rollers: |
|
1.Remove all four bolts shown in Figure 16.
Figure 16. Return roller mounting bolts.
2.Get assistance and lift the rollers into the position shown in Figure 17.
3.Thread the bolts with washers through the return roller holes and into the resaw.
Figure 17. Return roller placement.
Figure 15. Control panel positioning.
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
| |||
|
|
|
| |||
Model G0503 (Mfg. Since 12/08) | ||||||