SECTION 7: SERVICE
Power
Locking
Disconnect Switc
Tracking
Source
Conduit 
Co Ground
Always disconnect power to the machine before performing ser- vice adjustments. Failure to do this may result in serious personal injury.
Blade tracking consists of aligning the wheels to keep the blade centered when the wheel is rotat- ed under full tension. When replacing blades fine tuning may be necessary, but this entire process should not have to be repeated unless the wheels are removed.
About Service
This section is designed to help the operator with adjustments that were made at the factory and that might also need to be made during the life of the machine.
This section is provided for your convenience— it is not a substitute for the Grizzly Service Department. If any adjustments arise that are not described in this manual, then feel free to call the Grizzly Service Department at (570)
Similarly, if you are unsure of how to perform any procedure in this section, the Grizzly Service Department will be happy to guide you through the procedures or help in any other way.
Tools Needed | Qty |
Straightedge | 1 |
1 | |
Wrench 19mm | 1 |
Hex Wrench 4mm | 1 |
To track the blade: |
|
1.Disconnect the resaw from the power source!
2.Move the blade guides out of the way.
3.Turn the wheels by hand. If the bottom of the blade gullets do not remain approximately 1⁄16 " away from the front edge of the wheels, then adjust the tracking.
4.Place two flat bars under the conveyer belt and place a square against the fixed wheel as shown in Figure 53. Make note of the angle between the wheel and the square.