Test Run
Before starting the resaw, perform the pre- ceding assembly and adjustment instruc- tions, and read and understand the entire manual. Failure to follow this warning could result in serious personal injury or death!
To test run the resaw:
1.Make sure the wheel cover is closed and all tools or other objects are cleared away from the resaw.
2.Put on safety glasses and hearing protection, and make sure any bystanders are wearing safety glasses and hearing protection and are out of the way.
3.Turn the EMG STOP switch (shown in Figure 24) clockwise until it pops up.
Figure 24. Power switches.
4.Turn the POWER ON switch (shown in Figure 24) clockwise.
5.Press the MOTOR START button and imme- diately press the EMG STOP button. As you are standing in front of the machine, make sure that the blade is moving from left to right.
—If the blade is moving the wrong direction, swap the incoming power supply wires at the R and T locations on the main termi- nal block inside the electrical cabinet— this will reverse the blade direction.
—If the blade is moving in the correct direc- tion go to step 5.
5.Turn the EMG STOP switch clockwise until it pops up. Press the MOTOR START button again.
—If any problems occur, immediately press the EMG STOP button. Turn to
Troubleshooting on page 68 and correct the problem before operating the machine further.
—If you cannot easily locate the source of an unusual noise or vibration by yourself, please contact our service department at
(570)
6.Press the PUMP START button. Push the conveyor lever forward to test the conveyor belt. If the conveyor belt does not turn after pushing the conveyor lever forward, rotate the conveyor speed knob counterclockwise.
—If any problems occur, immediately press the EMG STOP button. Turn to
Troubleshooting on page 68 and correct the problem before operating the machine further.
—If you cannot easily locate the source of an unusual noise or vibration by yourself, please contact our service department at
(570)
Model G0503 (Mfg. Since 12/08) |