
Intel® NetStructureTMZT 7102 Chassis Management Module
CMM Installation and Removal
5.0CMM Installation and Removal
This chapter describes the steps necessary to install and set up the ZT 7102 Chassis Management Module (CMM). It includes instructions on unpacking, installing, and removing the CMM. Some systems may come with the CMM(s) already installed.
Caution: The ZT 7102 plugs into a dedicated chassis management slot. System components will be damaged if a standard 3U board is plugged into the chassis management slot.
5.1Unpacking
Check the shipping carton for damage. If the shipping carton and contents are damaged, notify Intel Customer Support. Retain the shipping carton and packing material for inspection by the carrier. Obtain authorization before returning any product to Intel. Refer to Appendix G, “Customer Support” for assistance information.
Caution: This board must be protected from static discharge and physical shock. Never remove any of the socketed parts except at a
5.2Connectivity
The ZT 7102 is intended to be installed as the CMM in a system's Chassis Management Slot. Where two Chassis Management Slots are available in a system, two CMMs may be installed. (They will automatically negotiate for active and standby roles.)
The ZT 7102 is designed to operate in a backplane providing
5.3Installing the CMM
The following instructions cover the mechanical aspects of installing the ZT 7102 CMM in a compatible system. For a better understanding of what happens when a CMM is absent from a system, see “Removing the CMM” on page 44.
Warning: When the system is plugged in, high voltages are present on the backplane. Do not reach into the enclosure.
Warning: Static electricity can damage electronic components. Wear a wrist strap grounded through one of the system's ESD ground jacks when servicing system components.
1.Take the necessary precautions to protect the ZT 7102 from static discharge. System power does not need to be off to install a CMM board.
2.Locate the system's dedicated CMM slot and remove the filler panel or existing CMM (see Section 5.4 for removal instructions).
Technical Product Specification | 43 |