Intel ZT 7102 manual Telco Alarm Sensors, Configuring the Telco Alarm Connector Pins, 121

Intel® NetStructureTMZT 7102 Chassis Management Module

Telco Alarm Sensors

22.0Telco Alarm Sensors

The faceplate of the CMM contains a µDB15 Telco alarm connector. See Section 2.6, “Face Plate” on page 20 and Section 2.16, “Telco Alarm Signal” on page 34 for more information on the Telco Alarm connector. By default, pins 1 through 4 are used by the CMM to clear major or minor alarms. The current state of pins 1 and 3 inputs are mapped to a GPIO on the CMM and can therefore be reconfigured as discrete sensor inputs.

22.1Configuring the Telco Alarm Connector Pins

To configure the telco alarm sensors as discrete inputs or to clear events, the following CLI command is used:

cmmset -l cmm -d TelcoInputs -v [sensors or clearEvents]

Where the value (-v) parameter is either:

sensors - Configures the telco alarm inputs as discrete input sensors. Or clearEvents - Configures the telco alarm inputs to be used to clear telco alarms.

22.2Obtaining the Configuration of the Telco Alarm Sensor Connector Pins

To retrieve the configuration of the Telco Alarm Sensor pins, use the following CLI command:

cmmget -l cmm -d TelcoInputs

This command will return a value of:

“sensors” - If the telco alarm input pins are being used as discrete sensor inputs.

“clearEvents” - If the telco alarm input pins are being used to clear minor and major alarms.

22.3Telco Alarm Connector Sensor Naming

The default name of the two telco alarm sensors is TAsensor1 and TAsensor2. These names are used and reported by the various CMM interfaces for the Telco Alarm Sensors. The sensors can be renamed using the following CLI command:

cmmset -l cmm -t TAsensorN -d sensorname -v [NewSensorName]

Where:

N - Is either “1” or “2” for TAsensor1 and TAsensor2, respectively.

NewSensorName - The new name that will be associated with the corresponding sensor.

Technical Product Specification 121