Intel® NetStructureTMZT 7102 Chassis Management Module
SNMP
19.4SNMP Trap Utility
The SNMP trap utility is utilized by the CMM management software to send SNMP trap messages to a remote application regarding any abnormal system events. When enabled, the CMM will issue SNMP v1 traps on port 162. The CMM can also be configured to issue SNMP v3 traps. The SNMP trap port can also be configured. For a description of all the traps that are issued, refer to Section 11.0, “Health Event Strings” on page 67.
19.4.1Configuring the SNMP Trap Port
To configure the SNMP Trap Port to a different port number, issue the command:
cmmset
Where Port Number is the desired SNMP Trap Port number.
19.4.2Configuring the CMM to Send SNMP v3 Traps
To configure the CMM to send SNMP v3 Traps, issue the command:
cmmset
19.4.3Configuring the CMM to Send SNMP v1 Traps
To configure the CMM to send SNMP v1 Traps, issue the command:
cmmset
19.5Configuring and Enabling SNMP Trap Addresses
The CMM allows up to five SNMP trap addresses destinations,
19.5.1Configuring an SNMP Trap Address
To configure an SNMP trap address, issue the command:
cmmset
where N is the number of the trap address from 1 to 5 that is being set, and IP address is the IP address of the trap receiver.
19.5.2Enabling and Disabling SNMP Traps
SNMP Trap addresses are enabled by default. To disable SNMP traps, issue the command:
cmmset
To enable SNMP trap addresses, issue the command:
cmmset
100 | Technical Product Specification |