Intel ZT 7102 manual Example CLI Commands Sheet 1, 139, Use Case CLI Command Return

Intel® NetStructureTMZT 7102 Chassis Management Module

Example CLI Commands

Appendix D Example CLI Commands

The following table shows examples of most CLI operations.

Note: The variable “N” (as in bladeN or fantrayN) represents the chassis slot number of the device being acted on (such as Blade5 or fantray1). Please refer to chassis documentation for slot, fan, fan tray, and power supply location and information.

Table 55. Example CLI Commands (Sheet 1 of 2)

Use Case	CLI Command	Return
Get current chassis	cmmget –l chassis –t “Temp Snsr 1”	Current Temperature for “Temp
temperature for “Temp
	–d current	Sensr 1” on chassis.
Snsr 1”.
Get fan tray 1	cmmget –l fantray1 –d presence	Fantray1 is present.
presence.		Fantray1 is not present.
Get the baseboard
temperature of blade		Current Temperature of “ambient
5 when the sensor is	cmmget –l blade5 –t “ambient temp”–d current
		temp” on blade 15.
named “ambient
temp”.
Find out if blade 15 is	cmmget –l blade15 –d presence	Blade15 is present.
present.		Blade15 is not present.
		Returns thresholds for upper
Get all thresholds for		non-recoverable, upper critical,
the +3.3 V sensor on	cmmget –l blade2 –t “+3.3V” –d thresholdsall	upper non-critical, lower
blade 2.		non-critical, lower critical, and lower
		non-recoverable.
Get the overall system	cmmget –l system –d health	Indicates if the entire system is
health.		healthy, or has health events.
Get a list of blades	cmmget –l system –d unhealthylocations	List of locations with active health
with problems		events.
Get the CMM’s overall		Indicates if the CMM is healthy or if
	cmmget –l cmm –d health	there are active health events on
health.
		the CMM.
Display the SEL of the	cmmget –l cmm –d sel	Displays a list of SEL entries (if any)
CMM		for the CMM.
Display the SEL of	cmmget –l blade19 –d sel	Displays a list of SEL entries (if any)
blade19.		for blade 19.
Get the version of	cmmget –l cmm –d version	Displays the version of firmware
firmware on the CMM		currently installed on the CMM.
Power off blade 19.	cmmset -l blade19 –d powerstate –v poweroff	Displays a success or failure
		message.
Power on blade 20.	cmmset –l blade20 –d powerstate –v poweron	Displays a success or failure
		message.
Reset blade 3.	cmmset –l blade3–d powerstate -v reset	Displays a success or failure
		message.
Get all of the chassis	cmmget –l chassis -t fru -d all	Displays a list of all of the FRU
FRU information.		information from the chassis.
Get all fantray2 FRU	cmmget –l fantray2 –t fru –d all	Displays a list of all of the FRU
information		information from the CMM.

Technical Product Specification 139