Crosscut Table |
|
Components and Hardware Needed: | Qty |
Crosscut Table | 1 |
Crosscut Table Brace | 1 |
2 | |
1 | |
Flat Washer 12mm | 1 |
Adjustable Handle | 1 |
Knob | 2 |
Flat Washer 8mm | 2 |
Tools Needed: | Qty |
An Assistant | 1 |
To install the crosscut table: |
|
1.Thread the
Figure 33. Installing the adjustable handle.
2.With the help of an assistant, place the cross- cut table on the pivot pin of the swing arm and slide the T-nut into the T-slot in the slid- ing table (see Figure 34).
Figure 34. Installing the crosscut table.
3.Slide two M8-1.25 T-nuts into the crosscut table brace.
4.Align the T-nuts in the crosscut table brace with the holes in the crosscut table and thread the M8-1.25 x 50 knobs, with 8mm flat washers, into the T-nuts as shown in Figure 35.
Crosscut
Table Brace
Figure 35. Installing the crosscut table brace.
G0451 14" Sliding Table Saw |