Dust Collection
The Model G0451 is equipped with two dust ports that should be properly connected to a dust col- lection system before operation.
Components and Hardware Needed: | Qty |
Blade Guard/Dust Hood | 1 |
Flat Washer 8mm | 1 |
Button Head Screw | 1 |
Dust Collection System | 1 |
5" Dust Hose (length as needed) | 1 |
5" Hose Clamp | 2 |
2½" Dust Hose (length as needed) | 1 |
2½" Hose Clamp | 2 |
Tools Needed: |
|
Hex Wrench 6mm | 1 |
Phillips Head Screwdriver | 1 |
To connect the dust ports to a dust collection system:
1.Secure a 5" dust hose to the dust port locat- ed under the saw table (Figure 51).
Figure 51. 5" dust port location.
2.Run the 5" hose to your dust collection sys- tem.
3.Slide the blade guard/dust hood over the riv- ing knife and attach it with an M8-1.25 x 40 button head cap screw and a flat washer as shown in Figure 52.
Figure 52. 2" dust port location.
4.Secure a 2½" dust hose to the dust port on the top of the blade guard as shown in Figure 52.
5.Run the 2½" hose over the hose support (Figure 53) and connect it to the dust collec- tion system.
Figure 53. Dust hose support in use.
6.Run a ground wire through the dust hose and attach the wire to the machine to pro- tect against static electricity.
G0451 14" Sliding Table Saw |