6.Check the surfaces of the table with a straightedge as shown in Figure 23.
Figure 23. Checking with a straightedge.
7.Use the set screws under both extension tables to level the top surfaces with the saw table.
8.When the surfaces are level, thread the bolt shown in Figure 24 against the underside of the small extension table to hold it level.
Figure 24. Small extension table support bolt.
9.Tighten all of the cap screws securing the tables.
Scale |
|
Components and Hardware Needed: | Qty |
Rip Fence Scale | 1 |
Cap Screws | 4 |
Hex Nuts | 2 |
Lock Washers 10mm | 4 |
Flat Washers 10mm | 4 |
Tools Needed: | Qty |
Hex Wrench 8mm | 1 |
Socket or Wrench 16mm | 1 |
To install the scale: |
|
1.Loosely thread four
Figure 25. Attaching the scale.
2.Secure the cap screws to the extension table with M10-1.5 hex nuts, but do not fully tighten.
3.Line the scale up with the top of the table and tighten the cap screws.
G0451 14" Sliding Table Saw |