Sliding Table |
|
Components and Hardware Needed: | QTY |
1 | |
Flat Washer 12mm | 1 |
Push Handle | 1 |
Edge Shoe | 1 |
Hold Down | 1 |
Sliding Table End Handle | 1 |
Sliding Table Lock Plate | 1 |
Tools Needed: | QTY |
Hex Wrench 4mm | 1 |
To assemble the sliding table components:
1.Remove the red shipping brace (Figure 39) and the screws indicated. Set the screws aside for use in the following steps.
Red Shipping
Brace
Figure 39. Sliding table.
2.Install the lock plate as shown in Figure 40 using 4 of the screws removed in the previ- ous step.
Lock Plate
Figure 40. Installing the lock plate.
3.Install the end handle, as shown in Figure 41, using the remaining screws removed in Step 1.
Table Lock
End Handle
Figure 41. Sliding table end handle.
4.The sliding table is locked in place when the table lock is in the position shown in Figure 41. Rotate the table lock 180˚ to unlock the sliding table.
G0451 14" Sliding Table Saw |