Woodstock W1701 owner manual Set Up, Unpacking, Inventory, Lifting Hazard

Page 11

W1701 1HP Shaper

SET UP

Unpacking

The SHOP FOX® Model W1701 has been carefully pack- aged for safe transporting. If you notice the machine has been damaged, please contact your authorized SHOP FOX® dealer immediately.

If any parts are missing, examine the pack- aging for the missing parts. For any missing parts, find the part number in the back of this manual and contact Woodstock International, Inc. at (360) 734-3482 or at tech-support@shopfox.biz

Inventory

The following is a description of the main components shipped with the SHOP FOX® Model W1701. Lay the components out to inventory them.

Note: Some parts and hardware may already be installed on the machine. make sure to check the machine when you use the inventory list.

LIFTING HAZARD!

Get help lifting and mov- ing the heavy components of this shaper.

SET UP

D

A

E

G

J

B

F

H

C

I

K

L

M

O

N

P

Figure 8. Component layout.

-8-

Image 11

Contents Copyright FEBRUARY, 2008 by Woodstock INTERNATIONAL, INC Model W1701PART# Description HP Shaper Page Contents Woodstock Technical Support SpecificationsIntroduction Standard Safety Instructions SafetyAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Shapers Use a Shop FOX Featherboard as Anti-kick back protection Avoiding Potential InjuriesGrounding Electrical110V Operation Extension CordsLifting Hazard SET UPUnpacking InventoryInventory List Machine PlacementCleaning Machine Main Contents QtyLaceration Hazard AssemblyTest Run Cutters vs. Router Bits OperationsGeneral Cutter Contact Hazard Spindle ElevationSpindle Direction To set the spindle height, do these stepsTable Inserts Fence PositioningFence Alignment Cutter FLY-APART Hazard Cutter InstallationThere are three set up positions for rub collars Accidental START-UP HazardAMPUTATION/LACERATION Hazard To install cutters and rub collars, do these stepsTo install the router bit collet, do these steps Router Bit InstallationStraight Shaping To set up the fence for partial edge removal, do these stepsTemplate Construction Tips TemplatesStarting pin operation Guard not shown for clarity Freehand ShapingLubrication MaintenanceMaintenance Schedule Table & BaseLoosen the belt adjustment bolts as shown in Figure ServiceBelt Adjustment To adjust belt, do these stepsTable Spacer Kit To install the table spacer kit, do these stepsTo replace the spindle cartridge assembly Spindle Cartridge ReplacementResurfacing a shaper fence on a Jointer ON/OFF Switch Motor & FWD/REV Switch Electrical Components & WiringParts PART# Description Parts ListCutterspindle Warranty Comments Warranty RegistrationBOX BELLINGHAM, WA Woodstock International INC