Woodstock W1701 owner manual Service, Belt Adjustment, To adjust belt, do these steps

Page 25

W1701 1HP Shaper

SERVICE

General

This section covers the most common service adjustments or procedures that may need to be made during the life of your machine.

If you require additional machine service not included in this section, please contact Woodstock International Technical Support at (360) 734-3482 or send e-mail to: tech-support@shopfox.biz.

Belt Adjustment

Your shaper uses a flat-type belt on two drum-style pul- leys, to compensate for different belt positions as the spindle height is adjusted.

To adjust belt, do these steps:

1.DISCONNECT SHAPER FROM POWER SOURCE!

2.Loosen the belt adjustment bolts as shown in Figure 37.

3.Slide the motor position to increase or decrease belt tension, so the belt is snug with about 1/4" deflec- tion when pressed lightly with your fingertips.

4.Tighten the belt adjustment bolts.

MAKE SURE that your machine is unplugged during all service proce- dures! If this warning is ignored, seri- ous personal injury may occur.

Figure 37. Adjusting belt tension.

SERVICE

-22-

Image 25

Contents PART# Description Model W1701Copyright FEBRUARY, 2008 by Woodstock INTERNATIONAL, INC HP Shaper Page Contents Introduction SpecificationsWoodstock Technical Support Standard Safety Instructions SafetyAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Shapers Use a Shop FOX Featherboard as Anti-kick back protection Avoiding Potential Injuries110V Operation ElectricalExtension Cords GroundingUnpacking SET UPInventory Lifting HazardCleaning Machine Machine PlacementMain Contents Qty Inventory ListLaceration Hazard AssemblyTest Run General OperationsCutters vs. Router Bits Spindle Direction Spindle ElevationTo set the spindle height, do these steps Cutter Contact HazardFence Alignment Fence PositioningTable Inserts There are three set up positions for rub collars Cutter InstallationAccidental START-UP Hazard Cutter FLY-APART HazardAMPUTATION/LACERATION Hazard To install cutters and rub collars, do these stepsTo install the router bit collet, do these steps Router Bit InstallationStraight Shaping To set up the fence for partial edge removal, do these stepsTemplate Construction Tips TemplatesStarting pin operation Guard not shown for clarity Freehand ShapingMaintenance Schedule MaintenanceTable & Base LubricationBelt Adjustment ServiceTo adjust belt, do these steps Loosen the belt adjustment bolts as shown in FigureTable Spacer Kit To install the table spacer kit, do these stepsTo replace the spindle cartridge assembly Spindle Cartridge ReplacementResurfacing a shaper fence on a Jointer ON/OFF Switch Motor & FWD/REV Switch Electrical Components & WiringParts PART# Description Parts ListCutterspindle Warranty Comments Warranty RegistrationBOX BELLINGHAM, WA Woodstock International INC