Woodstock W1701 owner manual Table Spacer Kit, To install the table spacer kit, do these steps

Page 26

W1701 1HP Shaper

Table Spacer Kit

The provided table spacer kit allows you to modify your shaper for use as a router table by raising the table. A higher table will allow you to make shallow cuts and uti- lize the upper blade area of most router bits with stan- dard-length shanks.

To install the table spacer kit, do these steps:

1.DISCONNECT SHAPER FROM POWER SOURCE!

2.Remove the spindle lock nut and any cutters or rub collars installed on the spindle.

3.Remove table from the shaper by undoing the seven bolts that secure it in place.

4.Loosen and remove the taper nut (see Figure 38) while holding the top of the spindle with a wrench.

5.Gently tap the bottom of the drawbar to knock the spindle loose.

6.Remove the spindle/drawbar assembly from the spindle cartridge.

7.Place the table spacers over the table mounting holes on the shaper.

8.Place the table on the spacers and secure it to the shaper with the hex bolts from the router table spacer kit (see Figure 39).

9.Save the removed table bolts for when you need to covert the Model W1701 back to use as a shaper.

10.Refer to Router Bit Installation on Page 17 for instructions on installing the collets and router bits.

Figure 38. Removing taper nut from drawbar.

��

��

��

��

SERVICE

Figure 39. Installing table spacers.

-23-

Image 26

Contents Copyright FEBRUARY, 2008 by Woodstock INTERNATIONAL, INC Model W1701PART# Description HP Shaper Page Contents Woodstock Technical Support SpecificationsIntroduction Safety Standard Safety InstructionsAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Shapers Avoiding Potential Injuries Use a Shop FOX Featherboard as Anti-kick back protectionExtension Cords Electrical110V Operation GroundingInventory SET UPUnpacking Lifting HazardMain Contents Qty Machine PlacementCleaning Machine Inventory ListAssembly Laceration HazardTest Run Cutters vs. Router Bits OperationsGeneral To set the spindle height, do these steps Spindle ElevationSpindle Direction Cutter Contact HazardTable Inserts Fence PositioningFence Alignment Accidental START-UP Hazard Cutter InstallationThere are three set up positions for rub collars Cutter FLY-APART HazardTo install cutters and rub collars, do these steps AMPUTATION/LACERATION HazardRouter Bit Installation To install the router bit collet, do these stepsTo set up the fence for partial edge removal, do these steps Straight ShapingTemplates Template Construction TipsFreehand Shaping Starting pin operation Guard not shown for clarityTable & Base MaintenanceMaintenance Schedule LubricationTo adjust belt, do these steps ServiceBelt Adjustment Loosen the belt adjustment bolts as shown in FigureTo install the table spacer kit, do these steps Table Spacer KitSpindle Cartridge Replacement To replace the spindle cartridge assemblyResurfacing a shaper fence on a Jointer Electrical Components & Wiring ON/OFF Switch Motor & FWD/REV SwitchParts Parts List PART# DescriptionCutterspindle Warranty Warranty Registration CommentsWoodstock International INC BOX BELLINGHAM, WA