Woodstock W1701 owner manual Woodstock International INC, Box Bellingham, Wa

Page 35

FOLD ALONG DOTTED LINE

Place

Stamp

Here

WOODSTOCK INTERNATIONAL INC.

P.O. BOX 2309

BELLINGHAM, WA 98227-2309

FOLD ALONG DOTTED LINE

TAPE ALONG EDGES--PLEASE DO NOT STAPLE

Image 35

Contents Copyright FEBRUARY, 2008 by Woodstock INTERNATIONAL, INC Model W1701PART# Description HP Shaper Page Contents Woodstock Technical Support SpecificationsIntroduction Standard Safety Instructions SafetyAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Shapers Use a Shop FOX Featherboard as Anti-kick back protection Avoiding Potential InjuriesGrounding Electrical110V Operation Extension CordsLifting Hazard SET UPUnpacking InventoryInventory List Machine PlacementCleaning Machine Main Contents QtyLaceration Hazard AssemblyTest Run Cutters vs. Router Bits OperationsGeneral Cutter Contact Hazard Spindle ElevationSpindle Direction To set the spindle height, do these stepsTable Inserts Fence PositioningFence Alignment Cutter FLY-APART Hazard Cutter InstallationThere are three set up positions for rub collars Accidental START-UP HazardAMPUTATION/LACERATION Hazard To install cutters and rub collars, do these stepsTo install the router bit collet, do these steps Router Bit InstallationStraight Shaping To set up the fence for partial edge removal, do these stepsTemplate Construction Tips TemplatesStarting pin operation Guard not shown for clarity Freehand ShapingLubrication MaintenanceMaintenance Schedule Table & BaseLoosen the belt adjustment bolts as shown in Figure ServiceBelt Adjustment To adjust belt, do these stepsTable Spacer Kit To install the table spacer kit, do these stepsTo replace the spindle cartridge assembly Spindle Cartridge ReplacementResurfacing a shaper fence on a Jointer ON/OFF Switch Motor & FWD/REV Switch Electrical Components & WiringParts PART# Description Parts ListCutterspindle Warranty Comments Warranty RegistrationBOX BELLINGHAM, WA Woodstock International INC