Woodstock W1701 To install cutters and rub collars, do these steps, AMPUTATION/LACERATION Hazard

Page 19

W1701 1HP Shaper

OPERATIONS

To install cutters and rub collars, do these steps:

1.DISCONNECT SHAPER FROM POWER SOURCE!

2.Slide the cutter(s) and rub collars onto the spindle in the correct orientation for your intended cut.

3.Install the keyed safety washer and nut as shown in

Figure 24.

CUTTER FLY-APART HAZARD!

Always use the keyed safety washer! The lock tang on this washer prevents the shaper cutter bit from loosening the spindle nut during operation.

4.Thread on and tighten down the spindle nut with the provided 23mm wrench, while holding the spindle at the top with an 8mm wrench, as shown in Figure 25.

5.Make sure the cutter rotates freely in the correct direction needed for the cut (in most cases this is the FWD direction on the FWD/REV switch, which is counterclockwise on the spindle).

6.Install applicable safety guard(s).

AMPUTATION/LACERATION

HAZARD!

Accidental contact with a cutter during operation will remove parts of fingers or large chunks of flesh. Safety guards greatly reduce this risk and must always be used when operating this machine!

Keyed

Safety

Washer

Figure 24. Placing the keyed safety

washer.

Figure 25. Tightening spindle nut.

-16-

Image 19

Contents PART# Description Model W1701Copyright FEBRUARY, 2008 by Woodstock INTERNATIONAL, INC HP Shaper Page Contents Introduction SpecificationsWoodstock Technical Support Standard Safety Instructions SafetyAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Shapers Use a Shop FOX Featherboard as Anti-kick back protection Avoiding Potential InjuriesGrounding Electrical110V Operation Extension CordsLifting Hazard SET UPUnpacking InventoryInventory List Machine PlacementCleaning Machine Main Contents QtyLaceration Hazard AssemblyTest Run General OperationsCutters vs. Router Bits Cutter Contact Hazard Spindle ElevationSpindle Direction To set the spindle height, do these stepsFence Alignment Fence PositioningTable Inserts Cutter FLY-APART Hazard Cutter InstallationThere are three set up positions for rub collars Accidental START-UP HazardAMPUTATION/LACERATION Hazard To install cutters and rub collars, do these stepsTo install the router bit collet, do these steps Router Bit InstallationStraight Shaping To set up the fence for partial edge removal, do these stepsTemplate Construction Tips TemplatesStarting pin operation Guard not shown for clarity Freehand ShapingLubrication MaintenanceMaintenance Schedule Table & BaseLoosen the belt adjustment bolts as shown in Figure ServiceBelt Adjustment To adjust belt, do these stepsTable Spacer Kit To install the table spacer kit, do these stepsTo replace the spindle cartridge assembly Spindle Cartridge ReplacementResurfacing a shaper fence on a Jointer ON/OFF Switch Motor & FWD/REV Switch Electrical Components & WiringParts PART# Description Parts ListCutterspindle Warranty Comments Warranty RegistrationBOX BELLINGHAM, WA Woodstock International INC