Woodstock W1701 owner manual Resurfacing a shaper fence on a Jointer

Page 28

W1701 1HP Shaper

Resurfacing Fence

The fence can be resurfaced or made flat with a jointer to correct any warping. This procedure should only be done if the fences will not align with each other after careful adjustment or they are warped.

To resurface the fence, do these steps:

1. Make sure the fence face mounting screws are far enough below the surface of the fence that they will not contact the jointer knives during operation.

Note: New fence faces can easily be made out of hard wood and resurfaced by using this same proce- dure.

2. Align both fence faces as straight as possible, using a straightedge or your jointer table as an alignment guide.

3. Resurface the fences on the jointer, as shown in Figure 42.

-25-

Figure 42. Resurfacing a shaper fence on a

jointer.

SERVICE

Image 28

Contents PART# Description Model W1701Copyright FEBRUARY, 2008 by Woodstock INTERNATIONAL, INC HP Shaper Page Contents Introduction SpecificationsWoodstock Technical Support Safety Standard Safety InstructionsAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Shapers Avoiding Potential Injuries Use a Shop FOX Featherboard as Anti-kick back protectionElectrical 110V OperationExtension Cords GroundingSET UP UnpackingInventory Lifting HazardMachine Placement Cleaning MachineMain Contents Qty Inventory ListAssembly Laceration HazardTest Run General OperationsCutters vs. Router Bits Spindle Elevation Spindle DirectionTo set the spindle height, do these steps Cutter Contact HazardFence Alignment Fence PositioningTable Inserts Cutter Installation There are three set up positions for rub collarsAccidental START-UP Hazard Cutter FLY-APART HazardTo install cutters and rub collars, do these steps AMPUTATION/LACERATION HazardRouter Bit Installation To install the router bit collet, do these stepsTo set up the fence for partial edge removal, do these steps Straight ShapingTemplates Template Construction TipsFreehand Shaping Starting pin operation Guard not shown for clarityMaintenance Maintenance ScheduleTable & Base LubricationService Belt AdjustmentTo adjust belt, do these steps Loosen the belt adjustment bolts as shown in FigureTo install the table spacer kit, do these steps Table Spacer KitSpindle Cartridge Replacement To replace the spindle cartridge assemblyResurfacing a shaper fence on a Jointer Electrical Components & Wiring ON/OFF Switch Motor & FWD/REV SwitchParts Parts List PART# DescriptionCutterspindle Warranty Warranty Registration CommentsWoodstock International INC BOX BELLINGHAM, WA