Woodstock W1701 Inventory List, Machine Placement, Cleaning Machine, Main Contents Qty

W1701 1HP Shaper

Inventory List

The following is a description of the main com- ponents shipped with the SHOP FOX® Model W1701. Lay the components out to inventory them, and refer to the list below and Figure 8.

Main Contents		Qty
A.	Shaper Unit	1
B.	Stand Bolt Bag	1
	— Carriage Bolts 5⁄16"-18 x 1⁄2"	16
	— Flat Washers 3⁄8"	16
	— Hex Nuts 5⁄16"-18	16
C.	Stand Side Panels	2
D.	Fence Assembly	1
E.	Table Inserts 1-3/8", 1-3/4"	1
D.	Special 26mm Flat Wrench	1
F.	Wrenches 8, 14, 23, 26, 30mm	1 Ea
G.	Router Bit Collets 1/4", 1/2" & Nut ....	1 Ea
H.	Fence Faces	2
I.	Guard	1
J.	Fence Lock Studs 5/16"-20	2
K.	Guard Mounting Post	1
L.	Guard Attachment Bar	1
M.	Miter Gauge Assembly	1
N.	Tie Bars	2
O.	Knob and Fence Bolt Bag	1
	— Star Knobs M8-1.25	2
	— Large Dia. Flat Washers 8mm	2
	— Hex Bolts M8-1.25 x 12	2
	— Phillips Head Screws M8-1.25 x 20	4
	— Flat Washers 8mm	6
	— Phillips Head Screws M4-.7 x 10	2
	— Hex Nuts M4-.7	2
P.	Table Spacer Kit	1
	— Hex Bolt M12-1.75 x 30	2
	— Hex Bolt M12-1.75 x 40	5
	— Lock Washer 12mm	7
	— Spacer 1/2"	7

Machine Placement

•Machine Mobility: Use the Model D2057

SHOP FOX® Heavy-Duty Mobile Base so you can make the most out of your shop space by moving the Model W1701 1HP Shaper out of the way when not in use. Contact your SHOP FOX® Dealer for price and availability.

•Working Clearances: Consider your current and future shop needs with respect to the machinery and the lumber to be shaped. Allow enough space for safe lumber support as the lumber is fed into the shaper and as it exits the machine.

•Outlets: Make sure the electrical circuits have the capacity to handle the amperage requirements for your Model W1701 1HP Shaper. Electrical outlets should be located near the shaper, so power or extension cords are clear of high-traffic areas.

Cleaning Machine

The table and other unpainted parts of your machine type are coated with a waxy grease that protects them from corrosion during ship- ment. Clean this grease off with a solvent clean- er or citrus-based degreaser. DO NOT use chlo- rine-based solvents such as brake parts cleaner or acetone—if you happen to splash some onto a painted surface, you will ruin the finish.

ALWAYS work in well- ventilated areas far from possible ignition sources when using solvents to clean machinery. Many solvents are toxic when inhaled or ingested. Use care when disposing of waste rags and towels to be sure they DO NOT create fire or environmental hazards.

SET UP

-9-