Woodstock W1814 manual jkIle, Kfk\jkilepfliaf`ek\i#fk\j\jk\gj1

N(/(+Fne\ijDXelXcD]^%('&'/"

K\jkIle

J<KLG

Once the assembly is complete, test run your machine to make sure it runs properly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review the KiflYc\j_ffk`e^ on GX^\ **%

If you still cannot remedy a problem, contact our Tech Support at (360) 734-3482 for assistance.

Kfk\jkilepfliaf`ek\i#[fk_\j\jk\gj1

(% Read the entire instruction manual first!

)% Make sure the cutterhead guard fully covers the cutterhead.

*% Make sure all tools and foreign objects have been removed from the machine.

+% Review J<:K@FEJ(Xe[)(SAFETY and CIRCUIT REQUIREMENTS) on GX^\j,Æ0and connect your machine to the power source.

,% Turn the jointer FE.

—The jointer should run smoothly with little or no vibration.

—Immediately stop the jointer if you suspect any problems. Refer to GX^\** to troubleshoot and fix any problems before starting the jointer again.

-%Turn the jointer F==, then remove the safety key from the ON/OFF paddle switch.

.% Lift the paddle switch to the ON position.

—If the jointer motor does not start, then the safety key is working properly and you have finished the test run.

—If the jointer motor starts when the safety key is removed, IMMEDIATELY DISCONNECT THE JOINTER FROM THE POWER SOURCE. Refer to GX^\**to troubleshoot the problem.

—If you still cannot solve this or any other problem that arises during the test run, call Tech Support.

Gifa\Zk`c\j k_ifne ]ifd k_\ dXZ_`e\ Zflc[ ZXlj\ j\i`flj \p\ `ealip% N\Xi jX]\kp ^cXjj\j [li`e^ Xjj\dYcp Xe[ fg\iXk`fe%

Cffj\ _X`i Xe[ Zcfk_`e^ Zflc[ ^\k ZXl^_k`edXZ_`e\ipXe[ZXlj\j\i`flj g\ijfeXc `ealip% B\\g cffj\ Zcfk_`e^ ifcc\[ lg Xe[ cfe^ _X`i k`\[ lg Xe[ XnXp]ifddXZ_`e\ip%

-18-