Woodstock W1814 manual $9\ckI\gcXZ\d\ek, Kfi\gcXZ\k\XeY\ck#fk\j\jk\gj1

N(/(+Fne\ijDXelXcD]^%('&'/"

J<IM@:<

M$9\ckI\gcXZ\d\ek

Your W1814 uses belts to drive both the cutterhead and the dust collection impeller. When these belts are not tensioned correctly, misaligned, or damaged, your jointer will not function properly.

The part number for the replacement drive belt is #X1814170; the part number for the replacement impeller belt is #X1814192.

Refer to the parts diagram in this manual when fixing belt problems. If you need further assistance, call our Tech Support at (360) 734-3482 or send e-mail to: k\Z_$ jlggfik7j_fg]fo%Y`q.

Kfi\Xc`^efii\gcXZ\k_\Zlkk\i_\X[Y\ck#[fk_\j\ jk\gj1

(% DISCONNECT JOINTER FROM POWER SOURCE.

)% While facing the rear of the jointer, tip it away from you until it rests on the fence assembly.

*% Remove the screws that hold the motor cover to the jointer base. Lift the cover off and set it aside.

+% Vacuum all dust and debris from the motor and belt areas.

,% Inspect the cutterhead belt for proper tension, straight alignment, and possible damage or wear.

Efk\1K_\Y\ck`jgifg\icpk\ej`fe\[`]`k[\]c\Zkj XYflk*Ð+n_\epflgi\jj[fnefed`[[c\f]k_\ Y\ckn`k_df[\iXk\gi\jjli\]ifdpflik_ldYfi ]fi\]`e^\i%K_\Y\ck`jgifg\icpXc`^e\[`]`kc`\j]cXk Xe[jkiX`^_kfek_\dfkfij_X]kXe[[i`m\glcc\p% 9\ck[XdX^\n`ccY\\m`[\ekfe`ejg\Zk`fe%

-%Loosen the four motor mounting cap screws (see =`^li\+-), but do not remove them.

.% Replace a damaged belt with a new one. Realign and re-tension the belt.

/% Tighten the motor mounting screws and replace the motor cover.

0% Test run the jointer. Repeat this procedure if necessary. If repeating this procedure does not solve the problem, call our Tech Support.

Motor Mount Screws

Fan Belt

Cutterhead Belt

=`^li\46. Motor mounting screws and

belt locations.

Kfi\gcXZ\k_\]XeY\ck#[fk_\j\jk\gj1

(% DISCONNECT JOINTER FROM POWER SOURCE.

)% Remove the motor cover, set it aside and check the belt for damage.

 Efk\1 @k`j_`^_cplec`b\cpk_Xkk_`j Y\ckn`cc\m\iY\d`jXc`^e\[fiflkf] k\ej`fe%@]`k`j#k_\af`ek\ie\\[jkf Y\j\im`Z\[YpXhlXc`]`\[k\Z_e`Z`Xe% :XccfliK\Z_Jlggfik%

*% If the belt is damaged, put one end of the new belt on the fan pulley, then fit the other end onto the drive pulley.

+% Replace the motor cover and secure it with the screws.

-30-