Xe`e, $9\ckj, ClYi`ZXk`fe, `cp\Zb, Dfekcp\Zb

N(/(+Fne\ijDXelXcD]^%('&'/"

D8@EK<E8E:<

>\e\iXc

For optimum performance from your machine, follow this maintenance schedule and refer to any specific instructions given in this section.

;X`cp:_\Zb

•Vacuum all dust on and around the machine.

•Empty debris from the dust collection bag. DO NOT use the jointer if debris obstructs the flow of material into the bag. Using the jointer when the chute is obstructed can lead to jointer malfunction and, possibly, fire. Failure to heed this warning can result in serious personal injury.

•Wipe down tables and all other unpainted cast iron with a metal protectant.

Dfek_cp:_\Zb

•Fence angle stops and cutterhead knife alignment.

•Belt tension, damage, or wear.

•Clean/vacuum dust from inside the cabinet and around the motor.

:c\Xe`e^

Cleaning the Model W1814 is relatively easy. Vacuum excess wood chips and sawdust, and wipe off the remaining dust with a dry cloth. If any resin has built up, use a resin dissolving cleaner to remove it.

Protect the unpainted cast iron surfaces on the table by wiping the table clean after every use—this ensures moisture from wood dust does not remain on bare metal surfaces and cause rust.

Keep tables rust-free with regular applications of a quality metal protectant.

M$9\ckj

To ensure optimum power transmission from the motor to the blade, the V-belt must be in good condition (free from cracks, fraying and wear) and properly aligned and tensioned (refer to the instructions on GX^\*').

D8B< JLI< k_Xk pfli dXZ_`e\ `j legcl^^\[ [li`e^ Xcc dX`ek\eXeZ\ gif$ Z\[li\j@]k_`jnXie`e^`j`^efi\[#j\i`$ fljg\ijfeXc`ealipdXpfZZli%

ClYi`ZXk`fe

Since all bearings are sealed and permanently lubricated, simply leave them alone until they need to be replaced. DO NOT lubricate them.

-26-