N(/(+Fne\i jDXelXc D]^%('&'/"
9Xj`Z:fekifcj
This section covers the basic parts and controls used during routine operations. Refer to =`^li\j),Xe[)- for basic parts and control locations.
8% FE&F==Jn`kZ_1This paddle switch starts and stops the cutterhead rotation.
The yellow part of the switch is a safety device. When you remove this part, the switch locks in the F==position. Always remove this yellow key when you leave the jointer work area. Removing the key prevents unsupervised persons in your shop (especially children) from easily or accidentally starting the jointer.
A
B
FG<I8K@FEJ
9% ;\gk_f]:lk8[aljkd\ekBefY1 Allows you to change the height of the infeed table to control the depth of cut.
:% =\eZ\K`ck`e^?Xe[c\1Lets you change the angle of the fence and lock it where desired. The fence can be quickly set to 90° (perpendicular to the tables), 45° inward, and 45° outward by setting and using the fence stops on the bracket assembly.
;% =\eZ\Jc`[`e^?Xe[c\1This handle lets you adjust and lock the position of the fence across the tables. 8CN8PJ firmly tighten the sliding handle before you begin operations. The position of the fence determines the maximum width of the cut as you pass your workpiece over the spinning cutterhead. E<M<Ioperate the jointer if 8EPpart of cutterhead is exposed on the work area.
=`^li\25. W1814 basic controls in front.
C
D
=`^li\26. W1814 basic controls in back.