Woodstock W1814 manual Ljkfcc\Zk`fe, =`li\22% Checking each end of the knife With a straightedge

N(/(+Fne\ijDXelXcD]^%('&'/"

,% Loosen the two jack screws, then, using a scrap wood block, push the knife blade down until both ends are sightly below the straightedge.

-%Using the 4mm hex wrench, turn each jack screw clockwise 1⁄8 of a turn at a time until each end of the knife (see =`^li\22) touches the straightedge evenly.

.% Rotate the cutterhead without disturbing the knife clamp to check the knife height.

—If the cutterhead knife is even with or brushes the straightedge and moves it slightly (1/8") forward and back when you turn the cutterhead, then it is set correctly. Make certain that the other knife is set in exactly the same manner.

—If the knife does not move the straightedge slight- ly (1⁄8") forward and back on the table, continue to make fine adjustments with the jack screws until the knife is set correctly. Make certain that the other knife is set in exactly the same manner.

/% When the knife height is set correctly, firmly tighten each of the knife clamp screws.

9cXZbC`e\jI\gi\j\ek JkiX`^_k\[^\Gfj`k`fej =ifdFm\i_\X[M`\n

=`^li\22% Checking each end of the knife

with a straightedge.

J<KLG

;ljk:fcc\Zk`fe

Kf`ejkXcck_\[ljkZfcc\Zk`feZ_lk\Xe[YX^#[fk_\j\ jk\gj1

(% Install the dust chute, as shown in =`^li\23.

)% Slip the bag clamp over the collection bag, then attach the collection bag to the chute and clamp it, as shown in =`^li\24.

=`^li\23. Installing the dust chute.

=`^li\)+% Attaching the dust collection

bag.

-17-