Woodstock W1814 manual Kfj\kk\`enXi+,²jkfg#fk\j\jk\gj1

N(/(+Fne\ijDXelXcD]^%('&'/"

-%Loosen the fence tilting handle, bring the fence to 90º with the square set against the fence, then tighten the handle.

 Efk\1B\\gk_\c`d`kgcXk\kXY`ek_\i\Xijcfkf] k_\c`d`kYcfZb%

.% Loosen the jam nut (located at the rear of the limit block shaft).

/% Using a screwdriver, turn the limit block set screw until the limit block shaft hits the fence.

0% Tighten the jam nut. The 90º stop is now set precisely.

J<IM@:<

Kfj\kk_\`enXi[+,²jkfg#[fk_\j\jk\gj1

(% DISCONNECT JOINTER FROM POWER SOURCE.

)% With the fence positioned over the bed and the sliding handle locked, loosen the fence tilting handle and release the limit tab.

*% Tip the fence towards the table as far as it will go, then tighten the fence tilting handle.

Efk\1 N_\epflk`gk_\]\eZ\kfnXi[jk_\kXYc\#`k n`ccjkfgn_\e`k_`kjk_\`enXi[jkfgYfck%

+% Use a machinist's combination square to check the angle of the fence, as shown in =`^li\42.

—If the fence leans 45º towards the table, the inward 45º stop is set correctly; move ahead to set the outward 45º stop.

—If the fence does not lean 45º towards the table, adjust the inward 45º stop by doing Jk\gj,$0.

,% Loosen the fence tilting handle, bring the fence to 45º, then tighten the handle just enough to keep the fence in position.

-%Remove the limit block from the fence bracket assembly and set it aside.

.% Using two 8mm wrenches, adjust the inward stop

bolt (see =`^li\43)until it hits the fence at precisely 45º inward, then tighten the jam nut (where the bolt meets the bracket assembly) while holding the stop bolt in place. Some trial-and-error will be required to set this stop correctly.

=`^li\42. Checking the inward 45º stop.

Inward

Stop Bolt

=`^li\43. Adjusting the inward stop.

-28-