BM 2610021333
Operation
Connecting Air Supply
| Never use oxygen or other bottled gases | FIG. 5 | |
! WARNING | |||
as a power source. Explosion may occur. |
| ||
|
| ||
Combustible gases and other bottled gases are dangerous |
| ||
and may cause the tool to explode. |
| ||
Never connect the tool to an air source ! WARNING that is capable of producing air pressure
exceeding 200 PSI. Excessive pressure can cause abnormal operation or cause the tool to burst, resulting in personal injury.
Use only clean, dry, regulated compressed air within the pressure range as marked on the tool. The correct pressure is the lowest pressure that will do the job.
Before connecting the tool to the air supply, check the air compressor regulator gauge to be sure it is functioning properly, and that the air pressure is within the operational range of the tool,
Do not exceed maximum recommended air pressure marked on the tool. Verify prior to using the tool that the air source has been adjusted
within the rated
To connect the tool to the compressor only use pneumatic air hoses that meet the following criteria:
•Minimum hose pressure rating, 200 psi
•Minimum hose inner diameter, 1/4 in.
•Maximum hose length, 100 ft.
To connect the air supply:
1.Snap the air hose onto the quick connector, see figure 5.
2.Check for air leakage. If leakage is noted, cease using the tool immediately and contact your BOSCH service center.
3.Be sure the air pressure gauge is operating properly and check it at least twice a day.
Cold Weather Operation
When using the tool in cold conditions the tool will cycle slower than usual while driving the first nails. The cycle rate will increase as the tool warms up. Keep tool warm to avoid reduced cycle rate.
Do not use a frozen tool. Allow tool to thaw ! WARNING before using. Moisture frozen in the tool may
impede internal components resulting in the risk of injury and/or tool damage.
8.