BM 2610021333
Operation
Firing Mode
Always ensure that tool is depressed ! WARNING against workpiece before pulling trigger.
This tool is not equipped with a work contact element and a nail will be fired each time the trigger is actuated. If tool is not depressed against workpiece when trigger is depressed a nail may fly freely or ricochet and strike you or another in the work area.
Your tool is equipped with two devices that require actuation before the tool will fire, the secondary trigger and the primary trigger. This tool operates in a sequential firing mode.
“Sequential” Firing Mode:
To use the tool to drive nails, the secondary and primary trigger must be used in a specific order:
1.Place nose of tool against workpiece.
2.The secondary trigger must be completely depressed against the handle, see figure 6.
3.The primary trigger must be pulled firmly and then released, see figure 6.
To continue operation in a separate location, move the tool along the work piece, repeating steps 1 through 3 as required.
Remove finger from the primary and secondary trigger when not driving nails.
Always carry the tool by the handle only. Removing your finger from the primary and secondary trigger when not operating the tool reduces the risk of unintentionally firing a nail and injuring yourself or someone else.
Do not drive a nail on top of another nail. ! WARNING If the tool is not moved before the primary
trigger is pulled again a second nail will be driven on top of the previously driven nail. This could cause the nail to be deflected or the tool to react in an unexpected manner.
FIG. 6
Primary
Trigger Secondary
Trigger
2
3
1 
Nail Unloading
!WARNING Always disconnect tool from air supply before removing nails from magazine.
This avoids the risk of unintentional operation.
!WARNING Do not disconnect air hose from the tool when the primary or secondary trigger is
depressed. The tool can fire when reconnected to air supply.
1.Disconnect air supply.
2.Push magazine latch and pull magazine to open position, see figure 3.
3.Grasp the rear of the nail strip and remove from magazine.
4.Remove all nails from magazine before changing to difference nail size.
9.