Campbell Hausfeld SB3232 specifications Troubleshooting Guide, Problem Cause Solution

Operating Instructions Model SB3232

Troubleshooting Guide

Stop using tool immediately if any of the following problems occur. Serious

! WARNING personal injury could result. Any repairs or replacements must be done by a Qualified Service Person or Authorized Service Center.

Problem	Cause	Solution
Air leaking at trigger valve	O-Rings in trigger valve housing are	Replace O-Rings. Check operation of Work Contact
	damaged	Element (WCE)
Air leaking between hous-	Loose screws in housing	Tighten screws
ing and nose	Damaged O-Rings	Replace O-Rings
	Damage to bumper	Replace bumper
Air leaking between hous-	Loose screws	Tighten screws
ing and cap	Damaged gasket	Replace gasket
Tool skips driving fastener	Worn bumper	Replace bumper
	Dirt in nose piece	Clean drive channel
	Dirt or damage prevent fasteners or	Clean magazine
	pusher from moving freely in magazine
	Damaged pusher spring	Replace spring
	Inadequate air flow to tool	Check fitting, hose or compressor
	Worn O-Ring on piston or lack of lubri-	Replace and lubricate O-Rings
	cation
	Damaged O-Ring on trigger valve	Replace O-Rings
	Air leaks	Tighten screws and fittings
	Cap gasket leaking	Replace gasket
Tool runs slow or has loss	Tool not lubricated sufficiently	Lubricate tool
of power	Broken spring in cylinder cap	Replace spring
	Exhaust port in cap is blocked	Replace damaged internal parts
Fasteners are jammed in	Guide on driver is worn	Replace guide
tool	Fasteners are not correct size	Use only recommended fasteners
	Fasteners are bent	Replace with undamaged fasteners
	Magazine or nose screws are loose	Tighten screws
	Driver is damaged	Replace driver
Air leaking at trigger valve	O-Rings or seals are damaged	Replace O-Rings or seals
stem

www.chpower.com

7